Thingiverse
Rope Pull Handle
by vance
25
Downloads
25
Likes
0
Makes
Our house has a pull-down set of stairs that go up into the attic.
A rope hangs down you have to pull on to lower the stairs. This is
a handle for the end of the rope. Just pass the rope (normal nylon
or cotton cord) through the hole in the handle and tie a knot to
secure it.
I've also added a strain relief object for the other end of the rope. If
you just tie off the rope on the other side of the hole, when you pull,
a lot of stress is put on the area right around the hole. This spreads
the stress out a bit, making it less likely that you will enlarge the
hole and have the rope pull through.
A rope hangs down you have to pull on to lower the stairs. This is
a handle for the end of the rope. Just pass the rope (normal nylon
or cotton cord) through the hole in the handle and tie a knot to
secure it.
I've also added a strain relief object for the other end of the rope. If
you just tie off the rope on the other side of the hole, when you pull,
a lot of stress is put on the area right around the hole. This spreads
the stress out a bit, making it less likely that you will enlarge the
hole and have the rope pull through.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!