Slicer Discord
Rosary holder – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Rosary holder

564 Downloads
448 Likes
360 Makes
Zum Modell
I made this so I could have something to hang my rosary on at night that was a bit nicer and more unique than just having a random hook or a nail in the wall (lol) - so I figured I would share it here too. I printed it in wood PLA, which came out nicely using the print settings I have specified, it also matches my dark wood grain style Ikea furniture which is a bonus., however I am sure it would look fine in any filament you desire. It has a little shelf to put a sacramental on too. Note: it is designed to be used with those ‘command’ style strips that allow you to pull them off the wall. The little recess at the bottom on the back allows you to get tweezers or needle nose pliers in there to grab the tabs while keeping them out of sight when its stuck up. I tested it and it works alright. The support material will probably get a bit stick, I just used a sharp hobby knife to clean it up, which does the job and it is not visible from the front. Thank you, and remember to pray the rosary
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ABS, Wood PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen