Rose, stem and leaves

This is a remix of the beautiful rose model (https://www.thingiverse.com/thing:3423963). I modified the design to make the stem stronger and easier to print, and added connection points for the leaves. Here is the step-by-step assembly manual.

What you need:
3D Printed Parts (7 pcs):
1x Rose Bud
1x Sepal
2x Stem halves
1x Small connector cube
2x Leaf branches

Tools & Consumables:
Super glue / Cyanoacrylate
Toothpick
Heat gun
Optional: Gloves

Assembly Steps:

Step 1: Prepare the parts
Ensure all parts are printed and clean from supports or brim.

Step 2-3: Stem Assembly Start
The stem is split into two halves to allow horizontal printing for better layer adhesion and strength. Take one half of the stem and insert the small connector cube into the designated square slot near the top.

Step 4-5: Gluing the Stem
Apply super glue along the entire flat surface of the second stem half. Use a toothpick to spread it evenly. Connect the two halves together, using the cube for alignment. Press