Rostock Max V2 Camera Mount

This is a mount for a Go-Pro style camera that fits on a Rostock Max V2. It uses one of the spacers below the bed and two screws to mount to. I made this to use the camera to make time-lapse videos and monitor my prints. It gives enough clearance for the hot end all the way to the edge, but you may run into problems if you have a layer fan installed on the same side as the mount. It was created with Autodesk Inventor 2016.

UPDATE: V2 out now! It is much lower and sits farther back. It shouldn't have problems with layer fan clearance and it is now adjustable. I will be uploading different length center pieces go to between the mount and the "top"