Thingiverse
Rotary Tool Support
von cmacarval
5.5k
Downloads
4k
Likes
5
Makes
This support was designed for Dexter Rotary Tool 150 W.
ATTENTION: BEFORE USING THE ROTARY TOOL MAKE SURE THAT THE LOWER SUPPORT AND THE UPPER CLAMP ARE PROPERLY FIXED.
Nuts, washers and screws (M5x25) are required for assembly.
January 5, 2021 - UPDATE: Lower Support Rev. A modified to solve the problem in one threaded hole according to LAERMEDIA issue on comments.
January 17, 2021 - UPDATE: Added picture to show thickness table and maximum grip dimensions.
ATTENTION: BEFORE USING THE ROTARY TOOL MAKE SURE THAT THE LOWER SUPPORT AND THE UPPER CLAMP ARE PROPERLY FIXED.
Nuts, washers and screws (M5x25) are required for assembly.
January 5, 2021 - UPDATE: Lower Support Rev. A modified to solve the problem in one threaded hole according to LAERMEDIA issue on comments.
January 17, 2021 - UPDATE: Added picture to show thickness table and maximum grip dimensions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!