Thingiverse
Rotary tool
von Bob-In
15
Downloads
13
Likes
0
Makes
Hello this is my first prototype. Rotary tool make with a tooth brush motor.
You will need a tooth brush motor, wire copper, conductive tape.
*You will need to make some adjustement : case hole for your screws, hole for your motor shaft (you can use glue if the hole is too big)
Update 29 octobre 2016:
Reupload the file to screw cap in the right direction.
You will need a tooth brush motor, wire copper, conductive tape.
*You will need to make some adjustement : case hole for your screws, hole for your motor shaft (you can use glue if the hole is too big)
Update 29 octobre 2016:
Reupload the file to screw cap in the right direction.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
