Rotating Display Plate

Rotating plate for displaying products, in my case, cakes.It is 25 cm in diameter and is powered by a microwave plate motor. It works flawlessly. I printed it in PLA and so far there have been no problems. However, if you think PLA is not resistant enough, you can print in PETG or ABS as long as you adjust the profile to these filaments. You can use M3 screws directly into the print to secure the motor or you can use M3 inserts also. To assemble the AC inlet you can use M3 screws also directly to print.The switch is a KCD101 21x15mm and is press fit secure. NOTE: Check that the switch, AC adapter and motor are the same size as those implemented in the profile. I made it with what I had at home, but I noticed that there are variations in the measurements of the components depending on the manufacturer.