Thingiverse
Rotating Hourglass Clamp
by Johanz
7
Downloads
12
Likes
0
Makes
### General
A holder for an hourglass that can be screwed to a wall. It is printed in one piece and the rotating part cannot be taken off due to the interlocking design.
### Printing
Must be printed with supports. Make sure there is exactly one layer of support between the two inside faces. After printing, rotation should be impossible, but with a strong twist, the connection is loosened and rotation is possible. The support aterial stays inside the object.
The supports between the lower faces should be easily removable.
### Dimensions
The Clamp is designed for cylindrical objects with 16mm diameter.
A holder for an hourglass that can be screwed to a wall. It is printed in one piece and the rotating part cannot be taken off due to the interlocking design.
### Printing
Must be printed with supports. Make sure there is exactly one layer of support between the two inside faces. After printing, rotation should be impossible, but with a strong twist, the connection is loosened and rotation is possible. The support aterial stays inside the object.
The supports between the lower faces should be easily removable.
### Dimensions
The Clamp is designed for cylindrical objects with 16mm diameter.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!