Rotating Modular Desk Organizer

All components are designed to print without support material and the modular components are all stackable, so you can mix and match as needed. The basis of the design is a base with planetary bearing that print in place, so the all the components on the platter rotate. perfect for when space is at a permium!


Three basic categories of parts: Base, Platter, and Modular components (And also a footing that is intended to be printed in TPU or another flexible material to increase the friction with the surface the organizer is on so the base will be less likely to rotate)


Base
1. Tight-tolerance
2. Loose-tolerance


Print the base "upside down" and you will not need supports. The base works fine with .2mm layer height and 20% infill, but if you are going to go with higher resolution or infill, I would do it on this one to make the interface as clean as possible and give it a little more heft. If you have a real nice printer, the tighter tolerance should be good recommen