Rotating table reusing old 2,3kg spool

I reused an old 2,3kg spool from 3d Prima to make a stand for painting things. Inner diameter 52mm.
Print the center roll and the stand with low infill (I used 10%).
Print the pin with high infill or 100%
The 300mm top solid. Two versions, one with a center knob to fit in the bearing, and one without.
You might want to glue the roll to the spool, and the pin to the stand to make them rigid.
2x608 bearings to put it together.
http://www.gose.se/filer/rotatingspool.mp4