Thingiverse

Rotorhazard Drone Racing Personal Lap timer - One Node

di Cerberus

5 Download

5 Likes

0 Makes

This is a standalone single node RotorHazard drone racing lap timer. Intended as a 'Personal Timer' for when you want to get out on your own and rip a few practice packs.

The Personal Timer is powered by an onboard 2s 18650 battery pack. With attached BCM for charging and voltage management.

There is no onboard PCB, rather the timer is built 'deadbug' style. Following the wiring schematics laid out on the RotorHazard documentation.- https://github.com/RotorHazard/RotorHazard/blob/master/doc/Hardware%20Setup.md

I would recommend using the fabulous RH_OTA software to configure the Arduino - https://github.com/szafranski/RH-ota

Parts required to build -

1 x RaspberryPi Zero W

1 x RX5808 Receiver Module (SPI Enabled)

1 x Arduino Nano

2 x 18650 battery

1 x BCM
https://tinyurl.com/y6x2oftc

1 x 3mm bi-color LED (For BCM status)

1 x Power Switch
https://tinyurl.com/y6tzbfzn

1 x shutdown switch with built in status LED
https://tinyurl.com/s5xcwu3

1

Choruslaptimer Delta5 drone Drones drone racing killakwads kwad LapTimer Quadcopter racing rotorhazard Choruslaptimer Delta5 drone Drones drone racing killakwads kwad LapTimer Quadcopter racing rotorhazard

Fonte

Thingiverse

Cosa serve per stampare: Intermedio Bassa affidabilità

Pezzo unico Viteria richiesta

Supporti 1/3

Assemblaggio 0/3

Impostazioni 1/3

Dimensioni piano 0/3

Post-lavorazione 1/3

Stampante

FDM / FFF

Formato file