RotorX Atom Session Canopy

Cube version coming soon.

Canopy for the RotorX Atom holds a Foxeer Arrow and GoPro Session. Components used in my build:

Kiss AIO FC/ESCs
Crossfire Micro RX
Unify Pro HV w/ dipole antenna
Foxeer Arrow V2

Must use 5mm round standoffs, and the two front standoffs need to be 4mm lower than the back 4. This was to account for the Kiss AIO board, on top of 4 nylon nuts. Other then that, this can be used at any height, so the components used don'd necessarily matter. I used 15mm all around, and there is a 12.5mm gap between the bottom of canopy and the frame.

Tube at the back to hold the VTX antenna, small gab between the VTX tube and the case to run a crossfire antenna up, and then through the small rube on the back of the GoPro. Mount other antenna on a zip tie off one of the back standoffs.

Printed out of TPU, positioned upright (as it would be on the quad), with support. Came out pretty clean , there are a few areas that could be optimized (particularly the bottom of t