MakerWorld
Office
Go to Model
Rotring 600 - magnetic case
17
Downloads
11
Likes
7
Makes
Hardware needed: 8-16 circular magnets 5x2mm This is a case designed for my favorite drafting pencil, the Rotring 600.I have added a pause on layer 49 where up to 8 magnet pairs can be press fit into pockets that will then be printed over to secure the magnets in place. This captive magnet approach dictates that the user pays attention to the polarity of the magnets, because their orientation is impossible to alter after the fact.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
