Thingiverse
Round-bottom flask stand
by kleinerELM
128
Downloads
128
Likes
2
Makes
Round-bottom flask stand for 250 mL flasks
empty flasks wont be very stable if this object will be printed with standard filaments
Recommendation: Apply three small drops of hot glue onto the contact surface between glass and plastic and press the flask into the stand. Remove the flask afterwards. The flask should then be much more stable.
I also made multiple test tube stands, which can be found here:
Version for 7 small tubes: https://www.thingiverse.com/thing:2460058
Version for 7 normal sized tubes: https://www.thingiverse.com/thing:2719817
Version for 7 large tubes: https://www.thingiverse.com/thing:2460095
Version for a single large tube: https://www.thingiverse.com/thing:2460016
empty flasks wont be very stable if this object will be printed with standard filaments
Recommendation: Apply three small drops of hot glue onto the contact surface between glass and plastic and press the flask into the stand. Remove the flask afterwards. The flask should then be much more stable.
I also made multiple test tube stands, which can be found here:
Version for 7 small tubes: https://www.thingiverse.com/thing:2460058
Version for 7 normal sized tubes: https://www.thingiverse.com/thing:2719817
Version for 7 large tubes: https://www.thingiverse.com/thing:2460095
Version for a single large tube: https://www.thingiverse.com/thing:2460016
kleinerELM also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
