Thingiverse
Round Lighthouse Lamp
von msouth468
8
Downloads
9
Likes
0
Makes
Round Lighthouse lamp.
The Bulb Base is sized to fit a snap in style candelabra light cord. However you will have to move the switch since the lamp is so tall. But it can be modified to fit whatever light you want to use. Use LEDs for the light source.
***DO NOT USE A STANDARD INCADENSENT BULB, IT WILL GET TO HOT.***
This is a large print that is over 28.5" once fully assembled.
Minimum bed size of 10.6''x7.9''x7.9''(270x200x200mm) is needed to fully print all the parts.
The Base, 1st, 2nd and Beacon floors have a small locator tab to help align them for gluing. Be sure to not glue the Beacon floor roof to the top or you won't be able to change the light bulb.
Enjoy the print.
The Bulb Base is sized to fit a snap in style candelabra light cord. However you will have to move the switch since the lamp is so tall. But it can be modified to fit whatever light you want to use. Use LEDs for the light source.
***DO NOT USE A STANDARD INCADENSENT BULB, IT WILL GET TO HOT.***
This is a large print that is over 28.5" once fully assembled.
Minimum bed size of 10.6''x7.9''x7.9''(270x200x200mm) is needed to fully print all the parts.
The Base, 1st, 2nd and Beacon floors have a small locator tab to help align them for gluing. Be sure to not glue the Beacon floor roof to the top or you won't be able to change the light bulb.
Enjoy the print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
