Slicer Discord
RP Classic flat back shell (regular and slim) – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

RP Classic flat back shell (regular and slim)

93 Downloads
30 Likes
43 Makes
Zum Modell
A replacement back panel for the Retroid Pocket Classic that is flat! The triggers are now part of the shell, a little less movement in them.You also need to swap out the little rubber inside the original shell triggers (see photos). I've got 2 versions:The regular one works with the stock battery, flattens the back, and curves the edges. I do actually find it more comfortableThe slim one requires swapping the battery to a smaller one. This requires soldering the stock battery pcb to the new battery, do at your own riskI used a 2200mAh 604368 lipo (6x43x68mm battery) https://www.amazon.com/dp/B0CNLNNL2DBattery life is certainly reduced, but I've found it fine.
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Polycarbonate
Mindest-Druckbett
68 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

NLD Design Shop veröffentlicht auch auf

21 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen