Thingiverse
RPG Knife Box
von BalladBlack
50
Downloads
40
Likes
0
Makes
A Dice Holder, Dice Tower, and Storable HP Tracker that all combines together to look like a knife. pommel cap is removable to keep hp tracker in place and store a few extra dice. The Blade is hollow to hold more dice. Handle and blade fit into each other but has holes set for small magnets (3-5 mm, I had some 6mm magnets that fit but true measurement came out to around 5.9).
Two blade options for a single edge or double edged look.
I did use supports on the handle set to 45 degree overhangs. The ramps inside for the dice tower function printed fine without them, the grooves in the handle did print with supports but removed easily enough, but you should be fine if you set supports to only hold the void where the cover goes at the guard of the handle.
Two blade options for a single edge or double edged look.
I did use supports on the handle set to 45 degree overhangs. The ramps inside for the dice tower function printed fine without them, the grooves in the handle did print with supports but removed easily enough, but you should be fine if you set supports to only hold the void where the cover goes at the guard of the handle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
