Thingiverse
RPI 2/3 drawout stack
von Markus1984
8
Downloads
3
Likes
0
Makes
A stack for raspberry pi 2 and 3, drawout and no screws.
It is flexible, only 2 hights or 10, you decide.
You only need to print 1 pcs of each sides and "stod" if you want. Or print all of file.
Update "slide" to v2 to prevent RPI board to flip inside stack when connect HDMI cable.
It is flexible, only 2 hights or 10, you decide.
You only need to print 1 pcs of each sides and "stod" if you want. Or print all of file.
Update "slide" to v2 to prevent RPI board to flip inside stack when connect HDMI cable.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!