Thingiverse
RPI Camera housing
por memmop
80
Descargas
55
Likes
0
Makes
This is a simple housing for the Raspberry Pi Wide angle camera with IR LEDs.
The front will print without supports but the back will need them.
The back will snap onto the front but may need a little super glue to keep in.
The back has 2 round recesses for 2 x 8mm magnets so that camera can be magnetically mounted.
An arm is to follows to mount to my Bibo 2 Touch.
The front will print without supports but the back will need them.
The back will snap onto the front but may need a little super glue to keep in.
The back has 2 round recesses for 2 x 8mm magnets so that camera can be magnetically mounted.
An arm is to follows to mount to my Bibo 2 Touch.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!