RSP-320 Stacker Rails

These rails join two Meanwell RSP power supplies together, slightly offsetting them so that the lower PSU's terminals are still accessible.

The rails have a "dent" in the top which allows for the Baldrick 8 LED controller board to still fit the top PSU using the standard Baldrick mounting plate.

The rails are attached using 4x M4 hex head screws each side which will be recessed flat with the rails themselves.

Two versions are available: the short version doesn't protrude past the bottom of the lower PSU so can be used with a separate PSU mount or base plate. The "Tall" version do protrude a little (around 1cm) below the based of the bottom PSU, providing "legs" so that PSU stack is raised off the floor.