RTI Priest Cheek Rest

Attention!! I NEED THE SHROUD DIAMETER AND BUTT PLATE WIDTH! Send me these dimensions so I can make the adjustments.

This is a cheek riser for the RTI Priest. The dimensions "are not to spec" and would appreciate feedback on overall design and ergonomics.

I've tried to keep with the theme of the Priest, with the minimal beveled edges where it is needed and have kept some sharp edges. The cheek riser comes in two pieces that are held in by 4 generic scope ring bolts. I didn't want to put the bolts into the meat of the riser as I would of had to make it wider as it may make your line of sight off-centre from the scope reticle. I've tried to make the bolting surfaces chamfered to reduce the discomfort (if there is any) on the cheek.

I recommend printing in ABS once the dimensions are adjusted.