Rubik's Cube for FDM printers

This is a work in progress, ill upload better versions as i improve them. For now, if people could give it a try and give me some feedback i would appreciate it! also feedback on how i present the instructions as this is my first upload and i don't know what im doing.

It will require some screws (m3 self tapping button heads 25mm long x 7)
some washers (m3 6.5mm - 7mm OD x 6)
and some springs which might be a bit harder to find, however i plan on redesigning it to use a common pen replacement spring, this one however uses ones that can be found on ebay fairly cheaply (10mm long, 6.5mm - 7mm wide and a wire width of 0.5mm x 6)
CA glue is required for the colour caps and the core. Also recommended, some petroleum jelly for lubrication.
i like to use disposable nail files for cleaning up any roughness but thats up to you.

youll need to print 8 corners, 12 edges and 6 centres. then four corner colour caps, four edge colour caps and 1 centre colour cap for each of the 6 colours.