Ruler Stop

SummaryI liked the design ot White_Panters ruler stop. But as my ruler was realy thin with only 0,75 mm his design just did not clamp it.So I redesigned it from scratch in SolidWorks, while copying his style. I also upgraded to a bigger screw and put the nut in the bottom. So you can now tighten the screw by hand, even without a cap.This actual 3MF-File is for a ruler 24.6 mm x 0.75 mm. Even without the screw it clamps nicely.SolidWorks-File is included, so you can configure the part to your specific ruler. Or you may ask me to make a specific version.I just added a cap, which is to be pressed on the head of a standard M5 hex head. Such a head should have a diameter of about 8.4 mm.You need:M5 x 20 hex socket ScrewM5 Nut ot be pressed in the bottomWasher 10x1 mm to be pressed in on topPrinting setupPrint it with the flat side on the printer bed. No support needed.I reccomend using raft, as I had several failures with the smal lip when trying without.Layer hight 0.2at least 3 perimeters