Thingiverse
RunCam 2 Case
von ptuxbury
69
Downloads
57
Likes
2
Makes
Protective Case for RunCam 2.
Design features:
- None of the vent/microphone holes are obstructed by this cover.
- There are small pilot holes in the tabs. Drill them out to fit the fastener you plan on using.
- The battery/SD card tab are covered by this design, so you'll have to rely on the USB port for charging and file transfer. In the near future I may add a second version that will allow access to these.
Design features:
- None of the vent/microphone holes are obstructed by this cover.
- There are small pilot holes in the tabs. Drill them out to fit the fastener you plan on using.
- The battery/SD card tab are covered by this design, so you'll have to rely on the USB port for charging and file transfer. In the near future I may add a second version that will allow access to these.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!