Thingiverse
Runcam 3 Mount for Vortex 250 Pro
door G999
3
Downloads
1
Likes
0
Makes
I designed this mount to attach a Runcam 3 that was wearing this TPU sleeve https://www.thingiverse.com/thing:2306842
The mount uses one of the protective lens jut outs to lock the front into place. Then a velcro strap can be wrapped around the underside of the mount, through the legs.
The mount sets the camera at a 20 degree angle.
You can slip the camera in and out of the mount without removing the VTX antenna.
I printed this in PLA at a 60% infill for strength. It has survived a half dozen crashes without issue.
The mount uses one of the protective lens jut outs to lock the front into place. Then a velcro strap can be wrapped around the underside of the mount, through the legs.
The mount sets the camera at a 20 degree angle.
You can slip the camera in and out of the mount without removing the VTX antenna.
I printed this in PLA at a 60% infill for strength. It has survived a half dozen crashes without issue.
G999 publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!