Thingiverse
Runcam 3 TPU Mount
von daless14
63
Downloads
48
Likes
0
Makes
The version in the photos is actually printed in PLA since I recently ran out of TPU filament, but it should print pretty much the same. Make sure your brim is thick enough so the edges dont curl during the print. This is a 20deg mount remixed from [Painless360's version](https://www.thingiverse.com/thing:2223472).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
