Thingiverse
RunCam Split WiFi Module Protector
door KPV
10
Downloads
5
Likes
0
Makes
Protective tray and sleeve for the RunCam Split WiFi Module.
Now you can throw the Wifi module in your toolkit without worrying about the pins getting bent.
The sleeve and the tray have 0.4mm of space between them and rely on a friction fit. There are little nubs on the sides of the tray to provide the right amount of friction to keep them together. If it's a little tight after you have printed it, slide the tray in and out a few times and it should loosen up a little.
Now you can throw the Wifi module in your toolkit without worrying about the pins getting bent.
The sleeve and the tray have 0.4mm of space between them and rely on a friction fit. There are little nubs on the sides of the tray to provide the right amount of friction to keep them together. If it's a little tight after you have printed it, slide the tray in and out a few times and it should loosen up a little.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
