Thingiverse
RUNOUT GUIDE
von StudioPolygon
36
Downloads
20
Likes
0
Makes
This is a remix from "Ender 3 Filament Guide" with a included runout sensor.
0.2 Layerhight
15% Infill
3 Perimeters
no support
- check the pictures for print orientation
The Microswitch is adjustable
Use a short ptfe tube to guide the filament to the switch, to make it easys to load the filament.
have fun :-)
0.2 Layerhight
15% Infill
3 Perimeters
no support
- check the pictures for print orientation
The Microswitch is adjustable
Use a short ptfe tube to guide the filament to the switch, to make it easys to load the filament.
have fun :-)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
