Thingiverse
Runout sensor filament guide
por JKCTX1
0
Descargas
1
Likes
0
Makes
This ferrule adapter will help guide your filament into the extruder after the filament sensor.
I replaced my PTFE tube with newer tubing that was a little bit smaller outer diameter so may have to adjust size by 5% increments in scale up or down. you want a snug fit or super glue it into ferrule.
Also, I did the first one in fast mode i have since done one in detail mode that has less deformities in finish so just FYI
I replaced my PTFE tube with newer tubing that was a little bit smaller outer diameter so may have to adjust size by 5% increments in scale up or down. you want a snug fit or super glue it into ferrule.
Also, I did the first one in fast mode i have since done one in detail mode that has less deformities in finish so just FYI
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!