Thingiverse
RUSH Star Man
von groan
11
Downloads
13
Likes
0
Makes
Designed this using Tinkercad so don't look for amazing quality. Intended to do a tree-topper but I think this will work better as just a LED lit light.
I was in the process of printing the ring-back but my printer jammed and broke my petsfang cooler! So that's not happening. Next will be installing my Direct Drive that's been in a drawer for 2 years.
Process is to print the Starman-filchange. This will have a pause to change filament after 3.5 hours. (Or was it 2.5) Either wya, after it does the ironing, it will pause.
I use white as the base so light passes through. Black to block out any other light.
Next print the ring-back. This gives you a space inside to put a standard LED strip. I sized it so it should be just about the right width for something like these https://www.amazon.ca/gp/product/B07W54PQDD
You'll want to cut away a small space from the ring, (i forgot to do this, just thinking of this now) to allow the light power cable to pass out the bottom. Glue the
I was in the process of printing the ring-back but my printer jammed and broke my petsfang cooler! So that's not happening. Next will be installing my Direct Drive that's been in a drawer for 2 years.
Process is to print the Starman-filchange. This will have a pause to change filament after 3.5 hours. (Or was it 2.5) Either wya, after it does the ironing, it will pause.
I use white as the base so light passes through. Black to block out any other light.
Next print the ring-back. This gives you a space inside to put a standard LED strip. I sized it so it should be just about the right width for something like these https://www.amazon.ca/gp/product/B07W54PQDD
You'll want to cut away a small space from the ring, (i forgot to do this, just thinking of this now) to allow the light power cable to pass out the bottom. Glue the
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!