Russian Gear Lock

This kind of lock is mostly found in russia in quite some different designs.


Instructions:

-Print everything in the orientation that needs no support. Only the housing needs support
-Make sure to print the housing in the direction where only the knob needs support!
-It does also work with no support but the knob doesn't look good then
-Print the rod twice (that's why it's called Rod_print2x.stl)

I slimmed down the rods (hole is 7mm, rods are 6mm now) so they are removable for disassembly and downscalable to 50% (maybe put a tiny strip of sticky tape to make them fit as snug as you want).
Print in picture was prototype at 50% scale.