Thingiverse
RX antenna mount v1
von BlueDeath
5
Downloads
2
Likes
0
Makes
This is still a prototype, it hasn't seen the sky yet!
The idea was to make a simple antenna mount for my quadcopter (x525) and tricopter. The copters have 10-12 mm square rods, so I planned using this with a zip tie.
I got Turnigy TGY-iA10 receivers, so this was designed for that, but I think it can be easily adapted to anything.
If you know the best alignment/placement for RX antennae, please advise.
Ideas for improvement are welcomed! (I know it's junky, it was a quick draw'n'print.)
This thing was made with Tinkercad.
The idea was to make a simple antenna mount for my quadcopter (x525) and tricopter. The copters have 10-12 mm square rods, so I planned using this with a zip tie.
I got Turnigy TGY-iA10 receivers, so this was designed for that, but I think it can be easily adapted to anything.
If you know the best alignment/placement for RX antennae, please advise.
Ideas for improvement are welcomed! (I know it's junky, it was a quick draw'n'print.)
This thing was made with Tinkercad.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!