Thingiverse
Ryan's 2" Micro Quadcopter Frame
door acetic
13
Downloads
11
Likes
0
Makes
This is the 3rd iteration of my first micro quadcopter frame design!
It is meant for 110x motors, 2" props in a pusher configuration, so "upside down" from how it prints. It measures 80mm motor to motor in front, 63mm motor in the rear and 80mm between front and rear. It has mounting holes for 20x20 FC/ESC stack, and fpv camera of your choice. Should be plenty of room to mount anything else you may want. Should be able to put a battery strap somewhere hopefully.
It is still a work in progress, but definitely is flyable. Just a bit heavier compared to carbon fiber frames, coming in at ~50g in my prints.
Ducts do have some benefits and drawbacks, not sure if it will matter much at this scale or just be detrimental. It's an experimental design, not sure if I will improve it or start from scratch, so any comments and feedback are welcome!
It is meant for 110x motors, 2" props in a pusher configuration, so "upside down" from how it prints. It measures 80mm motor to motor in front, 63mm motor in the rear and 80mm between front and rear. It has mounting holes for 20x20 FC/ESC stack, and fpv camera of your choice. Should be plenty of room to mount anything else you may want. Should be able to put a battery strap somewhere hopefully.
It is still a work in progress, but definitely is flyable. Just a bit heavier compared to carbon fiber frames, coming in at ~50g in my prints.
Ducts do have some benefits and drawbacks, not sure if it will matter much at this scale or just be detrimental. It's an experimental design, not sure if I will improve it or start from scratch, so any comments and feedback are welcome!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!