Thingiverse
Ryobi 40V Battery Base
por willtan930
68
Descargas
52
Likes
0
Makes
A battery base for a Ryobi 40 volt battery. Remix it for your custom applications. (See my Ryobi 18V to 40V adapter.)
Printing:
Supports - Yes
Infill - Your choice. I used 80%
Material - PLA
Post Printing:
Carefully break away supports with a knife and screwdriver. For the support in front of the terminal pins, I used a soldering iron to melt a slot in the infill in order to pry it out. Gently lift the battery release lever to free the inside supports. Hold open the battery release and grab it with needle nose pliers to free it and pull it out. Drill a hole in the base where you want wires to go through. (My original design had a hole built in but the supports it added through the hole made removal more difficult.)
Printing:
Supports - Yes
Infill - Your choice. I used 80%
Material - PLA
Post Printing:
Carefully break away supports with a knife and screwdriver. For the support in front of the terminal pins, I used a soldering iron to melt a slot in the infill in order to pry it out. Gently lift the battery release lever to free the inside supports. Hold open the battery release and grab it with needle nose pliers to free it and pull it out. Drill a hole in the base where you want wires to go through. (My original design had a hole built in but the supports it added through the hole made removal more difficult.)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
