Thingiverse
Ryobi Drill Bit Holder
von shilohmc33
11
Downloads
0
Likes
0
Makes
Ryobi Drill Bit Holder
This is my first custom piece created on Fusion 360. I made about 6 iterations of this before I settled with this design. I am not sure If it works with all Ryobi 18V drills but it works great on mine. If you need some different variations I'm happy to try and make that happen.
It only needs supports under the cylinder pin because its offset from the base. Everything else prints fine.
Thank you all and I hope you enjoy!
This is my first custom piece created on Fusion 360. I made about 6 iterations of this before I settled with this design. I am not sure If it works with all Ryobi 18V drills but it works great on mine. If you need some different variations I'm happy to try and make that happen.
It only needs supports under the cylinder pin because its offset from the base. Everything else prints fine.
Thank you all and I hope you enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
