Thingiverse
S13 Washer Fluid Cap
von usdm180sx
13
Downloads
5
Likes
0
Makes
This is a 60mm ID washer fluid cap made for Nissan s13 S-Chassis. I really don't know if it will work on other cars, but I did state Diameter for this print, so measure before you print.
I used PLA for th first print and it did warp after the first day of driving. I have not made it yet out of ABS or PTEG. Once I do make it, I will report my findings.
I used PLA for th first print and it did warp after the first day of driving. I have not made it yet out of ABS or PTEG. Once I do make it, I will report my findings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
