Thingiverse
Saab 9-3 #4401675
von AngryPancreus
6
Downloads
4
Likes
0
Makes
These are the snap clips that help hold the rear spoiler down on certain NG900's/OG9-3's(1994-2002). The top portion is tricky on FDM machines and usually needs to be printed in at least 0.6 or finer. SLA printers should be able to make these easily.
I had luck with a combination of the right temperature for my filament, cooling and speed, etc. Tested and fit, however I haven't found a strong enough material with my Ultimaker where the top doesn't want to break when it's snapped in. I will print it on my SLA machine and report back.
I had luck with a combination of the right temperature for my filament, cooling and speed, etc. Tested and fit, however I haven't found a strong enough material with my Ultimaker where the top doesn't want to break when it's snapped in. I will print it on my SLA machine and report back.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!