Slicer Discord
Sachet dispenser – 3D-Druckmodell von Thingiverse Thingiverse

Sachet dispenser

0 Downloads
1 Likes
0 Makes
Zum Modell
I was looking for a 1 rupee shampoo sachet dispenser could'nt find a reasonable one. so made my own :)
This can hold upto 30 shampoos, sufficient for 2 months on an average use. if stuck in the stack just quick push with a tooth brush from top.. (never happened to me so far as they are easy to slide down when you are taking from below.

+feature, if any shampoo is cut open then you can place max 2 pouches in the side of the container very useful feature.

Note : Best go with 3M double sided tape for installing in bathroom wall (clean the surfaces thoroughly before pasting)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen