Safety Razor Command Hook

Remixed design to hold my safety razor to the shower wall and allow it to dry. Uses a 3M Command strip to hold it, since this is an apartment.

Could use some minor improvements, such as lengthening the area the strip attaches to, as it is only as long as the adhesive area, so the little bit of non-adhesive area that sticks out (not the removal tab) is not covered. Also considering adding small channels on the back to more clearly mark where the strip goes.

I suggest printing with the back of the hook on the printer bed. If you have a heated bed, even better, since it will make the back smooth for the strip.