Sail Chafe Protector with retaining screw

On my boat I need sail chafe protectors which can be put on the guardrails, but also on the shrouds. There were some good designs available on Thingiverse, but usually only with one fixed diameter for the guardrail or shroud. Also, I found them difficult to print with ASA.

So is made my own remix, with these changes:
- Wire diameters 6, 7, 8, 10 mm are included
- Design optimized for easier printing with ASA (bevels instead of round edges), and a bit of tolerance to allow the parts to slide together. It is still intentionally hard to slide them together, but possible with a little soap or silicon grease.

Note that the bottom and top are different to allow for the locking screw.

Printing Details:

- Infill 43% hexagonal
- Filament: ASA
- Printed with 240°C Nozzle, 100°C bed, Ender3 S1 with enclosure

Additional Hardware Required:

- M3 x 8 stainless steel screw