Sakura D4 Front Lower Control Arm
por akumazedex
24
Descargas
21
Likes
0
Makes
Sakura D4 front lower control arm. Created this for better clearance and to use readily available end links since I kept braking mine. Depending on your printer quality, the fit might be a bit tight. This was designed intentionally, a little sanding or clean-up with a drill should make everything slide right in.
End links I used are Traxxas 5525.
Assembly; I reused as much factory pieces as I could, so all the obvious bits minus the end links should swap right over. To secure the end link, you can either drill a small hole through the arm and link once assembled and angles all set up and run a small screw, or you can use your standard super glue. Both have worked well enough.
End links I used are Traxxas 5525.
Assembly; I reused as much factory pieces as I could, so all the obvious bits minus the end links should swap right over. To secure the end link, you can either drill a small hole through the arm and link once assembled and angles all set up and run a small screw, or you can use your standard super glue. Both have worked well enough.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!