Slicer Discord
Sakura inner wheel beadlocks – 3D-printbaar model van MakerWorld MakerWorld
RC

Sakura inner wheel beadlocks

door BSD Customs · RC
9 Downloads
5 Likes
1 Makes
Model downloaden
Designed some beadlocks for the 3dsets Sakura as I did not feel like glueing the tires to the rims. Place the beadlock inside the tire with the inner tapered part towards the outside of the rim (the side you see when installed on the model). that is to clear the bosses from where the screws go into the rim. Then just screw the rim together like you normally would and it will pinch the tire beads against the rim and lock it in place. you can change the outer lip about +1 mm if you would prefer a bit more sidewall support but you'll start to see the tires internal ribs on the sidewalls. I used these tires off of amazon https://www.amazon.com/dp/B0CCYWG7HX?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Categorie
RC
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie