Thingiverse
SaldoT Extruder
von saldot
53
Downloads
23
Likes
2
Makes
Take one part Airtripper extruder and one part JohannRocholl Kossel Mini extruder. Mix them well and you end up with the SaldoT extruder.
No additional parts should be needed than the ones that comes with a standard Kossel Mini kit that uses the BOM from the reprap wiki.
I like airtrippers design but since it doesn't fit on a geared Nema 17 motor and requires a larger ball bearing then the one that came with my Kossel mini kit I decided to remix it and combine with Johann's extruder design.
Note: This is for a geared Nema 17 motor like the one e3d sells; http://e3d-online.com/Electrical/Stepper-Motors/Geared-stepper-motor
For a normal Nema 17 I suggest airtrippers original extruder.
Added holder for a geared Nema 17 holder. Baseplate is circular to allow for different mounting angles.
No additional parts should be needed than the ones that comes with a standard Kossel Mini kit that uses the BOM from the reprap wiki.
I like airtrippers design but since it doesn't fit on a geared Nema 17 motor and requires a larger ball bearing then the one that came with my Kossel mini kit I decided to remix it and combine with Johann's extruder design.
Note: This is for a geared Nema 17 motor like the one e3d sells; http://e3d-online.com/Electrical/Stepper-Motors/Geared-stepper-motor
For a normal Nema 17 I suggest airtrippers original extruder.
Added holder for a geared Nema 17 holder. Baseplate is circular to allow for different mounting angles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!