Samsung level on wireless headstrap

Printed on a ReprapGuru prusa i3 with a direct drive extruder and PLA filament. Models were sliced using Cura.

This replacement head strap uses the original earcups, axles, screws, plastic screw plates, and head strap padding of the headphones. The original headphones can be easily disassembled by removing the 4 torx screws in the head strap (the size is T5), removing the pin holders by sliding them upward, and pressing the pin holding the earcups out with a small screwdriver or similar. The padding is held onto the head strap with clips, a prying tool can be used to disengage the clips. Be careful to not damage the fake leather on the padding, as it tears and damages easily, especially if the headset is somewhat old.

IMPORTANT: These models are by no means perfect and requires some effort to fit correctly. The issues I encountered while doing the fix using these models are listed below:

The holes for the screws are too small and the standoffs have walls that are too thin. I d