Thingiverse
Samsung Mediastation
von iEik
4
Downloads
6
Likes
0
Makes
A mediastation primarely for a Samsung watch and a phone.
I used a basic Galaxy Watch charger, and a Ø = 90mm chargingpad.
BASE: Upscale by about 5%. Print upside down for best results, this is faster since there is less supports.
COVER: Upscale by about 5%. Print upside down, no supports needed.
WATCHTOWER: Print with the watchface facing down, no supports needed.
COVER WATCHTOWER: Print outside facing down, so the wire channel dont need supports.
Screws needed:
x4 M3 x 9mm for the WATCHTOWER -> WATCHTOWER COVER (M3x10mm works, but be careful so you don't damage the front.)
x1 M4 x 25mm for the BASE -> WATCHTOWER
x4 M3 x 10mm for the COVER -> BASE
I used a basic Galaxy Watch charger, and a Ø = 90mm chargingpad.
BASE: Upscale by about 5%. Print upside down for best results, this is faster since there is less supports.
COVER: Upscale by about 5%. Print upside down, no supports needed.
WATCHTOWER: Print with the watchface facing down, no supports needed.
COVER WATCHTOWER: Print outside facing down, so the wire channel dont need supports.
Screws needed:
x4 M3 x 9mm for the WATCHTOWER -> WATCHTOWER COVER (M3x10mm works, but be careful so you don't damage the front.)
x1 M4 x 25mm for the BASE -> WATCHTOWER
x4 M3 x 10mm for the COVER -> BASE
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!