Thingiverse
Samsung S24 Plus Vented Case
por benny-designs
1
Descargas
5
Likes
0
Makes
I needed a vented case for my phone to stop it overheating when charging, so I designed this. It fits comfortably in the hand with nice curved edges and a recess to access the side buttons with ease.
### Slicing recommendations
- Material: TPU
- Wall thickness: 2 Loops
- Infill: Grid 30%
- Supports: This is more complex, the bottom and side holes need supports, else you'll get stringing when bridging in TPU. But, regular supports won't really work well - as you'll need to cut them off with a knife and you'll lose the clean edges to the holes. So I designed an accompanying set of supports you print in PLA - and the 3MF has three pauses where you drop each support in place, you can see in the pictures. So when the pause prints, you add a support, then continue and repeat.
### Slicing recommendations
- Material: TPU
- Wall thickness: 2 Loops
- Infill: Grid 30%
- Supports: This is more complex, the bottom and side holes need supports, else you'll get stringing when bridging in TPU. But, regular supports won't really work well - as you'll need to cut them off with a knife and you'll lose the clean edges to the holes. So I designed an accompanying set of supports you print in PLA - and the 3MF has three pauses where you drop each support in place, you can see in the pictures. So when the pause prints, you add a support, then continue and repeat.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
