Thingiverse
Samsung S7 Case (Blank)
von KyroPaul
42
Downloads
23
Likes
0
Makes
I was tired of the existing cases either missing the correct bottom profile, or not being easily printable (due to bottom profile) in TPU.
There are 2 versions of this file. The TPU version has the top profile closed in and the PLA is open (so you can actually get the phone inside the case).
Both models are upside-down and you should flip this over so the back of the case is on the build surface.
OpenSCAD file also available.
There are 2 versions of this file. The TPU version has the top profile closed in and the PLA is open (so you can actually get the phone inside the case).
Both models are upside-down and you should flip this over so the back of the case is on the build surface.
OpenSCAD file also available.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!