Samurai Sword/Katana

This is a Katana designed specifically for the H series of printers. Designed after Daisho measurements, this sword is a minimum length of a main samurai's sword. An alternative for A/P/X series users is provided, just scaled down to 93%. This version is not tested. However, it should print just fine and be about 5 centimeters shorter. Assembly: Start by gluing the blade together - apply glue to the top piece, then insert the top piece into the middle piece. Important: the middle piece has connecters on both ends - one indent and one connecter. Make sure you have the pieces right. after that, you can glue the bottom blade part onto the upper ones. don't over glue it - that will make it look horrible. apply a bit of glue to around the bottom of the blade, then insert into the handle. it will be a loose fit that gets tighter as you go. let it dry, then done! Print Profile Info: I have had several prints fall over. Therefore, I have placed supports around each tall piece to ensure stabili