Thingiverse
Samus bracelets
por Kelly_Crystal
42
Descargas
40
Likes
0
Makes
I designed those bracelets, based on Super Smash Bros. design.
Both halfs should be printed in black. If you don't have black PLA, you can paint them.
Both lines should be printed in yellow. Glue the front line on the front half, then glue the rear line on the rear half.
The spot is white. It goes on the front.
Both halfs should be printed in black. If you don't have black PLA, you can paint them.
Both lines should be printed in yellow. Glue the front line on the front half, then glue the rear line on the rear half.
The spot is white. It goes on the front.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!