Thingiverse
Sand Casting Tools
49
Downloads
27
Likes
0
Makes
I took the extended tapered Sprue that Pauls Garage made and split it in half and made a pin for it in case you want to cast it.
I also recreated a surge trap and and riser that I saw on Swdweebs youtube channel. The Sprue should theoretically fit in a small hole on the surge trap.
I will also probably make some simple gates and if they work I might put them on here.
I uploaded the Sprue as one whole part instead of two halves because the two sides are not exactly the same size.
I also recreated a surge trap and and riser that I saw on Swdweebs youtube channel. The Sprue should theoretically fit in a small hole on the surge trap.
I will also probably make some simple gates and if they work I might put them on here.
I uploaded the Sprue as one whole part instead of two halves because the two sides are not exactly the same size.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
